Finger Joints

[gazaly]

I have a plan where I need to use finger joints to join a right angles 35mm square stock. One end has 3 fingers, the other 2. I was wanting any suggestions on a good way to cut these joints. IE anyone with a good jig design. I thought about using the router table with a biscuit cutter, or the workcentre using the blade. The problem with the latter is the fact that the stock is about 1000mm long. Any suggestions would be greatly appreciated.
Cheers,
Gary.

[barrysumpter]

The latest Australian woodworker (oops! I mean WoodSmith. Shame on me!) Mag has heaps of easy finger joint projects and articles. Its only about $5.95 and comes out about 6 times a year. Excellent format and great plans.

Barry G. Sumpter

[This message has been edited by barrysumpter (edited 18 May 2000).]

[This message has been edited by barrysumpter (edited 18 May 2000).]

[davidh]

Sorry to correct you Barry but the articles on finger joints are in Australian Woodsmith not woodworker and in issue No. 10.

Regards,

Dave

[gazaly]

Thanks guys, will seek out that mag.

Gary.

[gazaly]

OK, I can't find this mag anywhere! If anyone has a copy they no longer want I would very much appreciate it, or the name and number of the publisher, so I can contact them to order a back copy.

Cheers,
Gazza.

[Noel Butcher]

Australian Woodsmith is published bi-monthly by

Media Properties Australia Pty Ltd.
Suites 3 & 4
22 Elizabeth Street
Artarmon NSW 2064
Phone 02 9904 8512
Fax 02 9419 7257

[gazaly]

Cheers again,

Gazza.