fanlee
7th August 2016, 04:32 PM
Hi.
I have attached a photo that shows:
1. the spindle at max Z- ..... it's clear that after installing a bit and setting up the workpiece a lot of Z travel is lost.
2. there is about 7cm from the bottom of the spindle housing to the end of the spindle.
Is it OK to simply raise the spindle in the housing to claw back some Z travel ?
I have asked the suppliers and been ignored.
Thanks,
Rob.
I have attached a photo that shows:
1. the spindle at max Z- ..... it's clear that after installing a bit and setting up the workpiece a lot of Z travel is lost.
2. there is about 7cm from the bottom of the spindle housing to the end of the spindle.
Is it OK to simply raise the spindle in the housing to claw back some Z travel ?
I have asked the suppliers and been ignored.
Thanks,
Rob.