PDA

View Full Version : Outboard Turning - Chuck or Faceplate - How rare are they?



Braxtonatoraxto
9th September 2016, 03:29 PM
So after the purchase of my TeknaTool Lathe and enjoying the turning that I have done so far - I was wondering what are the options for outboard turning?

I am hoping to do some slightly larger bowls/platters that are larger than the swing over the bed of the lathe - so where is the best place to find faceplates and/or scrolls for outboard turning?

I seem to come up fairly blank when looking in the most common places - what are other people's thoughts on where I should be looking?

Thanks in advance.


Paul

Sawdust Maker
9th September 2016, 06:21 PM
As you're in Qld

Gary Pye (http://www.garypye.com/)

Vermec (http://www.vermec.com/)

or even Carbatec (https://www.carbatec.com.au/)