woodguy_1
30th August 2005, 12:51 PM
Has anyone here tried their hand at bent lamination pen blanks?
If so could you give a quick how to?
dai sensei
30th August 2005, 08:56 PM
Welcome Woodguy1.
Not sure what you mean by bent laminations? If you mean a thin layer or layers curving through your timber, you can cut your blank with a bandsaw/scrollsaw then put it back together with a thin laminate(s) glued between. You can use any good glue, but CA is best if you are in a hurry.
Hope this helps.