Teknatool manuals

[Chrism3]

I asked Teknatool to send me a digital copy of a TL1200 manual, but they said they didn't have one. But they did send me manuals for the TL1000 and TL1500. They also included instructions for replacing bearings and pulleys/belts.
If anyone needs a copy of one of these let me know.

[chuck1]

Ooo that's for the yellow and black lathe. I would be keen to know how to get Bearing out! I bet there is no easy way to adjust tailstock alignment
The evil thing it is!

[KBs PensNmore]

Chuck, which way is it out? Did you check it with a double ended Morse taper? Just asking as my Symtec is out and I just move it to one side to keep it in line.
Kryn

[chuck1]

The old yellow one has that much adjustments it's a right pain in the tailstock! I swapped the bed.

[RuthF]

Hi Chrism3, I've been looking for a manual for a TL1000 for a while. Could you email it to me?

[Chrism3]

Sure, pm your email address

[powderpost]

Hi Chrism3, can you put a copy in the "Manuals Library"?, see the banner on top of the thread.

Jim

[Mr Unknown]

I asked Teknatool to send me a digital copy of a TL1200 manual, but they said they didn't have one. But they did send me manuals for the TL1000 and TL1500. They also included instructions for replacing bearings and pulleys/belts.
If anyone needs a copy of one of these let me know.

Can i get my hands on these please, i do have the TL1000 manual but it didnt have instructions in regards to bearings and pulleys/belts. Ill send you a pm.

[twosheds]

Hi Chrism3

Like Mr Unknown I have the TL1000 manual but need instructions as to removal of bearings and pulleys. PM sent.

Regards
Twosheds

[Mr Unknown]

Hi Chrism3

Like Mr Unknown I have the TL1000 manual but need instructions as to removal of bearings and pulleys. PM sent.

Regards
Twosheds

I have uploaded them to the manuals section if anyone else wants a copy.

http://www.woodworkforums.com/f307/teknatool-manuals-210914#post2013599

[TobyNZ]

I asked Teknatool to send me a digital copy of a TL1200 manual, but they said they didn't have one. But they did send me manuals for the TL1000 and TL1500. They also included instructions for replacing bearings and pulleys/belts.
If anyone needs a copy of one of these let me know.

Hi Chris
Any chance you could send me the TL-1500 manual? I just picked one of these up over the weekend and would love to have the manual to go with it.

Cheers

[WarrickNZ]

I asked Teknatool to send me a digital copy of a TL1200 manual, but they said they didn't have one. But they did send me manuals for the TL1000 and TL1500. They also included instructions for replacing bearings and pulleys/belts.
If anyone needs a copy of one of these let me know.

I would love a copy of the TL1000 manual and replacement instructions as I have just purchased an older secondhand TL1000 :)
Thanks
Warrick

[WarrickNZ]

And I just found them elsewhere on the forum, thanks!

[Mr Unknown]

Yep, see post number #10 in this thread, there is a link to the manuals you can download.