IINoddyII
5th March 2017, 03:32 PM
Hi,
have a Triton TPT15 thicknesser that I've had for ages, but hasn't had much use so am reluctant to sell it for parts..
About six months ago I heared a big clunk and everything stopped. The blades rotate, but not the feed rollers.
Opened up the thicknesser and found a few of the sprockets where broken.. Managed to get new ones from Grizzly in the US, however the issue persists.
Here is a short vid of what is going on.
(noise turned off :D )
https://vimeo.com/206781446
Seems most likely to me that perhaps i've broken part 72 https://d27ewrs9ow50op.cloudfront.net/partsdiagramthumbs/1000/g0477_pl_3_1000.png
https://d27ewrs9ow50op.cloudfront.net/partsdiagramthumbs/1000/g0477_pl_6_1000.png
Does anybody have any recommendations for a machine repairer in Canberra, or should I give up on the likelyhood that I am going to be unable to fix it ?
Cheers
have a Triton TPT15 thicknesser that I've had for ages, but hasn't had much use so am reluctant to sell it for parts..
About six months ago I heared a big clunk and everything stopped. The blades rotate, but not the feed rollers.
Opened up the thicknesser and found a few of the sprockets where broken.. Managed to get new ones from Grizzly in the US, however the issue persists.
Here is a short vid of what is going on.
(noise turned off :D )
https://vimeo.com/206781446
Seems most likely to me that perhaps i've broken part 72 https://d27ewrs9ow50op.cloudfront.net/partsdiagramthumbs/1000/g0477_pl_3_1000.png
https://d27ewrs9ow50op.cloudfront.net/partsdiagramthumbs/1000/g0477_pl_6_1000.png
Does anybody have any recommendations for a machine repairer in Canberra, or should I give up on the likelyhood that I am going to be unable to fix it ?
Cheers