RedShirtGuy
22nd March 2017, 01:15 PM
The usual not an auction disclaimer...
I've finally gotten my 10" jointer/thicknesser up and running, so it's time to sell off ol' faithful.
Asking for $180.
- 6" jointer, made in Taiwan (no brand markings that I can see);
- 3 HSS knives have only been sharpened (ground) once since I purchased them new and are still cutting well;
- New bearings in cutter block as of this morning;
- ~1155mm length;
- The tables are flat and sitting co-planar (movement and transportation may muck that up though), with no surface rust but some light splatter stains that don't effect the use;
Much prefer pickup from Ballarat (Cardigan Village) but can deliver within 100ish km for diesel dollars if need be.
Being the honest idiot that I am...whilst it runs smoothly, it has a screamingly loud squeal coming from somewhere. The bearings I replaced this morning were shagged, but the new ones don't seem to have made much difference. Otherwise I haven't put much effort into locating the problem. Ear muffs are a must...as they should be anyway.
Cheers :)
I've finally gotten my 10" jointer/thicknesser up and running, so it's time to sell off ol' faithful.
Asking for $180.
- 6" jointer, made in Taiwan (no brand markings that I can see);
- 3 HSS knives have only been sharpened (ground) once since I purchased them new and are still cutting well;
- New bearings in cutter block as of this morning;
- ~1155mm length;
- The tables are flat and sitting co-planar (movement and transportation may muck that up though), with no surface rust but some light splatter stains that don't effect the use;
Much prefer pickup from Ballarat (Cardigan Village) but can deliver within 100ish km for diesel dollars if need be.
Being the honest idiot that I am...whilst it runs smoothly, it has a screamingly loud squeal coming from somewhere. The bearings I replaced this morning were shagged, but the new ones don't seem to have made much difference. Otherwise I haven't put much effort into locating the problem. Ear muffs are a must...as they should be anyway.
Cheers :)