MWF FEED
9th January 2018, 11:30 PM
Not exactly metalworking, but workshop. I'm wondering if anyone has used drop in anchors and can give some tips on drill bit size. I had an overhead application and thought the drill bit should be the same size as the anchor. However after inserting I wasn't as confident. I may have just been overthinking it. I don't have a setting tool however and was just going to punch the set to the "seems about right" setting :)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=201417&goto=newpost)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=201417&goto=newpost)