Vintage clamps.

[MWF FEED]

Can never have enough clamps... I also like putting them back into action.
Picked up these two a while back..the F-clamp is an Aussie made Gyrex... has been a bit abused in its time, and looks like the screw and nut have been replaced..done a good job,although the handle is a bit puny.
The other is a fabricated type.. the frame is made from two pressed sides that that have been welded around the perimeter...it too has been subjected to stress beyond its capabilities and is twisted.
Hoping that someone has either of these clamps ..as i would like to copy the pad dimensions.
Ken.
Attached Images

http://metalworkforums.com/images/attach/jpg.gif GEDC0979gy.jpg (http://metalworkforums.com/attachment.php?attachmentid=371887&d=1517962318) (74.5 KB)
http://metalworkforums.com/images/attach/jpg.gif GEDC0992.JPG (http://metalworkforums.com/attachment.php?attachmentid=371889&d=1517962364) (149.0 KB)
http://metalworkforums.com/images/attach/jpg.gif GEDC0983.JPG (http://metalworkforums.com/attachment.php?attachmentid=371888&d=1517962341) (218.5 KB)
http://metalworkforums.com/images/attach/jpg.gif GEDC0981.jpg (http://metalworkforums.com/attachment.php?attachmentid=371890&d=1517962395) (70.8 KB)
http://metalworkforums.com/images/attach/jpg.gif GEDC0989.JPG (http://metalworkforums.com/attachment.php?attachmentid=371891&d=1517962434) (187.1 KB)




Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=201524&goto=newpost)