MWF FEED
26th February 2018, 09:40 PM
Last year I stated Building myself a new Garage in Sydney. I built the Garage around my Mill and A year on I finally have power and can start Tinkering. I got the Little Myford up and running tonight. Next up Figure out if I can run the 2 speed 3 Phase mill off a VFD or if I need to source a new VFD compatible motor. :U
Attached Images
http://metalworkforums.com/images/attach/jpg.gif 1519640122347916525871.jpg (http://metalworkforums.com/attachment.php?attachmentid=372284&d=1519640186) (256.7 KB)
http://metalworkforums.com/images/attach/jpg.gif 15196399940791060778320.jpg (http://metalworkforums.com/attachment.php?attachmentid=372283&d=1519640045) (247.4 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=201598&goto=newpost)
Attached Images
http://metalworkforums.com/images/attach/jpg.gif 1519640122347916525871.jpg (http://metalworkforums.com/attachment.php?attachmentid=372284&d=1519640186) (256.7 KB)
http://metalworkforums.com/images/attach/jpg.gif 15196399940791060778320.jpg (http://metalworkforums.com/attachment.php?attachmentid=372283&d=1519640045) (247.4 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=201598&goto=newpost)