MWF FEED
30th August 2018, 06:50 PM
Have shown these 4 tools to other engineering people but no one has been able to tell me what they are used for - bear with me as I am referring to the illustration from memory.
Largest dia. tool is marked Brevette SMP lyon SGDG and + CORRECTION ANGULAIRE -
tool with 4 holes at the end of it locks when pushed up but is free when pulled down - no locking screws at 4 holes
tool with damaged taper is branded Macson has morse taper both ends and sleeve goes up and down and rotates
next tool unbranded and sleeve can be pushed up against spring pressure - ball detents below knurled ring look like they're intended to hold a tool. good luck , I am having problem loading photo
Attached Files
http://metalworkforums.com/images/attach/htm.gif arbor 1.htm (http://metalworkforums.com/attachment.php?attachmentid=375113&d=1535613654) (24.2 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202263&goto=newpost)
Largest dia. tool is marked Brevette SMP lyon SGDG and + CORRECTION ANGULAIRE -
tool with 4 holes at the end of it locks when pushed up but is free when pulled down - no locking screws at 4 holes
tool with damaged taper is branded Macson has morse taper both ends and sleeve goes up and down and rotates
next tool unbranded and sleeve can be pushed up against spring pressure - ball detents below knurled ring look like they're intended to hold a tool. good luck , I am having problem loading photo
Attached Files
http://metalworkforums.com/images/attach/htm.gif arbor 1.htm (http://metalworkforums.com/attachment.php?attachmentid=375113&d=1535613654) (24.2 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202263&goto=newpost)