MWF FEED
24th September 2018, 06:50 PM
I will admit that I am not the tidiest person in the shed (or home for that matter) but this has come as a bit of a surprise (or shock) to me.
A clean bench top,
DSC05823 e.jpg (http://metalworkforums.com/attachment.php?attachmentid=375724&d=1537769737)
This is the first time in six years that this bench has had a clean top and that was only because I had just installed the draws.
A clean bench is not that bad you say, well after realising this top was clear I looked and the welding bench, nothing on it. Then a look at the benches at the other end of the shed. One is clean, the other has stuff on. That's lucky I was getting a bit worried.
But the worst and shocking thing is that tomorrow I am off to the scrapyard. Taking stuff to the scrapyard is not how its done, I bring thinks home from scrapyards.
I need a lay down this is all too much.
Tony
Attached Images
http://metalworkforums.com/images/attach/jpg.gif DSC05823 e.jpg (http://metalworkforums.com/attachment.php?attachmentid=375724&d=1537769737) (136.6 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202375&goto=newpost)
A clean bench top,
DSC05823 e.jpg (http://metalworkforums.com/attachment.php?attachmentid=375724&d=1537769737)
This is the first time in six years that this bench has had a clean top and that was only because I had just installed the draws.
A clean bench is not that bad you say, well after realising this top was clear I looked and the welding bench, nothing on it. Then a look at the benches at the other end of the shed. One is clean, the other has stuff on. That's lucky I was getting a bit worried.
But the worst and shocking thing is that tomorrow I am off to the scrapyard. Taking stuff to the scrapyard is not how its done, I bring thinks home from scrapyards.
I need a lay down this is all too much.
Tony
Attached Images
http://metalworkforums.com/images/attach/jpg.gif DSC05823 e.jpg (http://metalworkforums.com/attachment.php?attachmentid=375724&d=1537769737) (136.6 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202375&goto=newpost)