MWF FEED
31st December 2018, 12:10 PM
Here is a 4" stink pipe which is only thin gal.
It's totally rotted at the bottom so my idea is to cut the pipe off near the eave and slip a plastic replacement pipe over it and down to the elbow below.
Thin gal is not easy to cut with a hacksaw because of jamming. What's your suggestion for a suitable tool to cut this through one handed while hanging on to a ladder for dear life 20 feet up in the air ?
P1030856.JPG (http://metalworkforums.com/attachment.php?attachmentid=377525&d=1546215421)
PS must fix that window one day.
Attached Images
http://metalworkforums.com/images/attach/jpg.gif P1030856.JPG (http://metalworkforums.com/attachment.php?attachmentid=377525&d=1546215421) (112.4 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202777&goto=newpost)
It's totally rotted at the bottom so my idea is to cut the pipe off near the eave and slip a plastic replacement pipe over it and down to the elbow below.
Thin gal is not easy to cut with a hacksaw because of jamming. What's your suggestion for a suitable tool to cut this through one handed while hanging on to a ladder for dear life 20 feet up in the air ?
P1030856.JPG (http://metalworkforums.com/attachment.php?attachmentid=377525&d=1546215421)
PS must fix that window one day.
Attached Images
http://metalworkforums.com/images/attach/jpg.gif P1030856.JPG (http://metalworkforums.com/attachment.php?attachmentid=377525&d=1546215421) (112.4 KB)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202777&goto=newpost)