Removing blind rolled pin

[MWF FEED]

What's the best way to remove a blind rolled pin.
I have a handle from a mates electric wheel chair, only does half a turn and has been sheared off. Thread size is 1/4"UNC and the rolled pin would be about 2.5mm
The handle is threaded internally, then to hold the threaded piece in place, they've installed a rolled pin, not all the way through, but about half way.
Blind Rolled Pin2.jpg (http://metalworkforums.com/attachment.php?attachmentid=377662&d=1547384655)Blind rolled pin.jpg (http://metalworkforums.com/attachment.php?attachmentid=377663&d=1547384682)
Hopefully the pics will explain it better.
Thanks in advance.
Kryn
Attached Images

http://metalworkforums.com/images/attach/jpg.gif Blind rolled pin.jpg (http://metalworkforums.com/attachment.php?attachmentid=377663&d=1547384682) (89.3 KB)
http://metalworkforums.com/images/attach/jpg.gif DSCF0653.jpg (http://metalworkforums.com/attachment.php?attachmentid=377661&d=1547383837) (69.8 KB)
http://metalworkforums.com/images/attach/jpg.gif Blind Rolled Pin2.jpg (http://metalworkforums.com/attachment.php?attachmentid=377662&d=1547384655) (80.6 KB)




Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202818&goto=newpost)