MWF FEED
19th February 2019, 04:00 PM
Anyone seen one of these Tru-grip chucks before?
Taper is NT40, there's a small center piece inside the body and looks like there should be some type of collet to go with it.
https://uploads.tapatalk-cdn.com/20190219/674c87d2a5d175b0d021039873673c94.jpg
https://uploads.tapatalk-cdn.com/20190219/379e433f2e189967cebbdc4cc8fe4152.jpg
https://uploads.tapatalk-cdn.com/20190219/a7cfc1ed54bf8f5148395786c339fa3e.jpg
https://uploads.tapatalk-cdn.com/20190219/3fe6e667ebce81f0ead4e3131e1afbb6.jpg
Steve
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202954&goto=newpost)
Taper is NT40, there's a small center piece inside the body and looks like there should be some type of collet to go with it.
https://uploads.tapatalk-cdn.com/20190219/674c87d2a5d175b0d021039873673c94.jpg
https://uploads.tapatalk-cdn.com/20190219/379e433f2e189967cebbdc4cc8fe4152.jpg
https://uploads.tapatalk-cdn.com/20190219/a7cfc1ed54bf8f5148395786c339fa3e.jpg
https://uploads.tapatalk-cdn.com/20190219/3fe6e667ebce81f0ead4e3131e1afbb6.jpg
Steve
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=202954&goto=newpost)