artful bodger
14th March 2019, 06:01 PM
Posted a thread a while ago about making this (http://www.woodworkforums.com/f8/round-window-226156) small opening round window, see picture below.
450774 It drew a bit of flak due to the robustness (or lack of) of the hinge. Which was also a concern to me. It was also suggested that 2 quadrant stays might have been better than one.
This one is slightly larger at 450mm OD. Tracked down a sturdier stainless steel "Hatch hinge" from a ship chandler this time. The hinge came with a 1/4 inch removable clevis pin but the fit of the pin was woefully sloppy. Bought a 5/16 clevis pin and drilled through the hinge on a home made jig to get a fit with way less play in it.
450777 Outside/main frame is again WRC and the opening frame is King Billy pine.
Also put 2 chromed brass quadrant stays on this one to match the look of the stainless steel hinge.
Turned a drip groove on the OD of the opening frame as well.
With the main frame each segment is screwed and glued to the segment underneath using Kleiberit 303 glue. The King billy opening frame is just glued (no screws) using Epiglue epoxy glue.
A bit happier with this one.
Last shot shows finished item with an unturned built up twin.
450780 450781 450782450783 450784 450785
450774 It drew a bit of flak due to the robustness (or lack of) of the hinge. Which was also a concern to me. It was also suggested that 2 quadrant stays might have been better than one.
This one is slightly larger at 450mm OD. Tracked down a sturdier stainless steel "Hatch hinge" from a ship chandler this time. The hinge came with a 1/4 inch removable clevis pin but the fit of the pin was woefully sloppy. Bought a 5/16 clevis pin and drilled through the hinge on a home made jig to get a fit with way less play in it.
450777 Outside/main frame is again WRC and the opening frame is King Billy pine.
Also put 2 chromed brass quadrant stays on this one to match the look of the stainless steel hinge.
Turned a drip groove on the OD of the opening frame as well.
With the main frame each segment is screwed and glued to the segment underneath using Kleiberit 303 glue. The King billy opening frame is just glued (no screws) using Epiglue epoxy glue.
A bit happier with this one.
Last shot shows finished item with an unturned built up twin.
450780 450781 450782450783 450784 450785