MWF FEED
26th March 2019, 12:30 PM
Full disclaimer - I'm normally a wood tinkerer! :D
Recently become the owner of a Hafco HM-32 Mill, so I shot out and got myself a ER32 collet chuck to get me started with a few projects that I have in mind.
Discovered that one of the quirks with the HM-32 mill is the 1/2" BSW draw bar. From what I have seen in my limited internet browsing, most tools seem to be for a 12mm thread draw bar.
Although I am tempted to grab myself a bit of mild steel rod and fabracobble a bodgey 12mm draw bar, was wondering if others had come across a similar issue and what their solution was?
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=203092&goto=newpost)
Recently become the owner of a Hafco HM-32 Mill, so I shot out and got myself a ER32 collet chuck to get me started with a few projects that I have in mind.
Discovered that one of the quirks with the HM-32 mill is the 1/2" BSW draw bar. From what I have seen in my limited internet browsing, most tools seem to be for a 12mm thread draw bar.
Although I am tempted to grab myself a bit of mild steel rod and fabracobble a bodgey 12mm draw bar, was wondering if others had come across a similar issue and what their solution was?
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=203092&goto=newpost)