MWF FEED
2nd April 2019, 06:50 PM
My mini lathe's aluminium multi step pulley has two large (47mm) bearings in its hub.
I am replacing them right now. The bearing are a fairly neat fit but both bearing outers will spin inside the hub if I try them with my fingers.
What's the correct procedure here ? A smear of Loctite ? I have some of the blue Loctite.
https://i.postimg.cc/Wqtxzn5r/P1030878.jpg (https://postimg.cc/Wqtxzn5r)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=203125&goto=newpost)
I am replacing them right now. The bearing are a fairly neat fit but both bearing outers will spin inside the hub if I try them with my fingers.
What's the correct procedure here ? A smear of Loctite ? I have some of the blue Loctite.
https://i.postimg.cc/Wqtxzn5r/P1030878.jpg (https://postimg.cc/Wqtxzn5r)
Read the full thread at metalworkforums.com... (http://metalworkforums.com/showthread.php?t=203125&goto=newpost)