PDA

View Full Version : Chestnut vase/open turning



Dalboy
19th August 2019, 06:06 AM
Just finished this Chestnut Burr today it stands 6 1/2" tall by 6 1/2" across. Finished with sander sealer and satin lacquer, I then gave it a wax with woodwax22 as the satin finish was not what I wanted but the high gloss would have been too glossy.
Well it could have been a knuckle buster kept all parts of me in the safe zone behind the rest.

459911459910459909459908

tony_A
19th August 2019, 08:47 AM
Thats a nice piece Derek and the finish suits it. I like the effect of the natural edge and voids, give it character.

Tony

smiife
19th August 2019, 08:44 PM
Very nice Derek , there, s a few teeth on that burl , hope you still
have your nuckles :oo:

Dalboy
19th August 2019, 09:46 PM
Thank you both. Yes it certainly has teeth and they are quite sharp on this piece, as I stated all body parts kept well out of the way:bgth: