MWF FEED
2nd September 2019, 07:00 PM
I have been asked to make a couple of cartridge board up.
How would you attach the cartridges to the back?
I thought of epoxy but think it will get too messy and slow.:?
Something like this.
b16b003d7e2e22fbad9a0b54ba95d53e.jpg (https://metalworkforums.com/attachment.php?attachmentid=381738&d=1567407451)
Attached Images
https://metalworkforums.com/images/attach/jpg.gif b16b003d7e2e22fbad9a0b54ba95d53e.jpg (https://metalworkforums.com/attachment.php?attachmentid=381738&d=1567407451) (48.1 KB)
Read and reply to the full thread at metalworkorums.com.... (https://metalworkforums.com/showthread.php?t=203863&goto=newpost)
How would you attach the cartridges to the back?
I thought of epoxy but think it will get too messy and slow.:?
Something like this.
b16b003d7e2e22fbad9a0b54ba95d53e.jpg (https://metalworkforums.com/attachment.php?attachmentid=381738&d=1567407451)
Attached Images
https://metalworkforums.com/images/attach/jpg.gif b16b003d7e2e22fbad9a0b54ba95d53e.jpg (https://metalworkforums.com/attachment.php?attachmentid=381738&d=1567407451) (48.1 KB)
Read and reply to the full thread at metalworkorums.com.... (https://metalworkforums.com/showthread.php?t=203863&goto=newpost)