MWF FEED
26th November 2019, 11:40 AM
SAM_0548.jpg (https://metalworkforums.com/attachment.php?attachmentid=383424&d=1574725400)SAM_0546.jpg (https://metalworkforums.com/attachment.php?attachmentid=383422&d=1574725237)SAM_0547.jpg (https://metalworkforums.com/attachment.php?attachmentid=383423&d=1574725311)SAM_0548.jpg (https://metalworkforums.com/attachment.php?attachmentid=383424&d=1574725400)
Here are the pics of 2 tool holders. Pic 2 is of the smaller unit. The cap has a slotted hole so it can adjust to the tool bit size. A ramp on one side and square cut groove on other side to capture tool bit. I run it backwards in the shaper to reduce chatter. That puts the tool behind the centre of pull. I have crashed the bit into a job and stalled the shaper. By accident. No damage to bit or holder. It's an 18" shaper. Only problem so far is in deep slots. The fat holder head makes it hard to get low in the slot. I'm buying some bigger bits next order.
BC
Attached Images
https://metalworkforums.com/images/attach/jpg.gif SAM_0546.jpg (https://metalworkforums.com/attachment.php?attachmentid=383422&d=1574725237) (201.6 KB)
https://metalworkforums.com/images/attach/jpg.gif SAM_0547.jpg (https://metalworkforums.com/attachment.php?attachmentid=383423&d=1574725311) (173.1 KB)
https://metalworkforums.com/images/attach/jpg.gif SAM_0548.jpg (https://metalworkforums.com/attachment.php?attachmentid=383424&d=1574725400) (234.7 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=204198&goto=newpost)
Here are the pics of 2 tool holders. Pic 2 is of the smaller unit. The cap has a slotted hole so it can adjust to the tool bit size. A ramp on one side and square cut groove on other side to capture tool bit. I run it backwards in the shaper to reduce chatter. That puts the tool behind the centre of pull. I have crashed the bit into a job and stalled the shaper. By accident. No damage to bit or holder. It's an 18" shaper. Only problem so far is in deep slots. The fat holder head makes it hard to get low in the slot. I'm buying some bigger bits next order.
BC
Attached Images
https://metalworkforums.com/images/attach/jpg.gif SAM_0546.jpg (https://metalworkforums.com/attachment.php?attachmentid=383422&d=1574725237) (201.6 KB)
https://metalworkforums.com/images/attach/jpg.gif SAM_0547.jpg (https://metalworkforums.com/attachment.php?attachmentid=383423&d=1574725311) (173.1 KB)
https://metalworkforums.com/images/attach/jpg.gif SAM_0548.jpg (https://metalworkforums.com/attachment.php?attachmentid=383424&d=1574725400) (234.7 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=204198&goto=newpost)