PDA

View Full Version : Alien UFO Bowl



Pat
1st January 2020, 05:20 PM
After breaking a screw in another blank, I dug thru the junk pile and found this piece of ugly, junky, cracked Camphor. It said it was a challenge piece and to make a ufo bowl.
Now me being a boofhead turner, couldn't resist the challenge of turning something completely out of balance . . . My sense of fun is seriously warped!
285x70. Spray poly. There was no way I was applying a finish on the lathe, I like my fingers attached!

466385466386466387466388466389

I like the compression figure, a branch grew from the trunk.

orraloon
2nd January 2020, 10:31 AM
It does have plenty visual stimulation going on.:2tsup:
Regards
John

smiife
2nd January 2020, 07:27 PM
Hi pat , nice mate , beautiful grain pattern:2tsup:

Skew ChiDAMN!!
2nd January 2020, 08:22 PM
Nothing there that a little epoxy fill wouldn't fix! :innocent:

Good decision not to apply a friction finish... ;)