MWF FEED
21st March 2020, 09:00 PM
I just faced off the drill press table, and the result is that it is now cupped in the centre by 0.2mm.
First question is, do I try to get it better?
Second question, if the DIAMETER of the table is 285mm, and the cupping is 0.2mm, do I bump the headstock by 0.1mm at the 285mm point? (or 0.2mm?)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=204733&goto=newpost)
First question is, do I try to get it better?
Second question, if the DIAMETER of the table is 285mm, and the cupping is 0.2mm, do I bump the headstock by 0.1mm at the 285mm point? (or 0.2mm?)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=204733&goto=newpost)