MWF FEED
14th May 2020, 09:00 PM
I've been looking at a soda blasting gun. There is a few options out there, but after some first hand experience.
There is a total tools model, and a more expensive Danish Air Boy model.
The air boy states it needs 450LPM... and the TTI model requires '90 psi'. Has anyone had success with a smaller compressor?
Mine is 255L/min free air delivery, with a pump displacement of 350L/min - in other words, one of the bigger single phase models before you start going 3 phase.
My intended use would be cleaning of small parts, at a low duty cycle.
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205040&goto=newpost)
There is a total tools model, and a more expensive Danish Air Boy model.
The air boy states it needs 450LPM... and the TTI model requires '90 psi'. Has anyone had success with a smaller compressor?
Mine is 255L/min free air delivery, with a pump displacement of 350L/min - in other words, one of the bigger single phase models before you start going 3 phase.
My intended use would be cleaning of small parts, at a low duty cycle.
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205040&goto=newpost)