MWF FEED
8th September 2020, 06:40 PM
I知 after a medium size straight edge, 300 mm
I知 not wanting to spend more than about $80 Au at present,
So , I知 not expecting to be able to buy a high end precision edge.
I will be mainly using it on some woodwork plane builds , that I知 planing , using metal,to check edges once ive filled them.
(One small note point , I do have a small surface plate, but I知 away from my workshop till we come out of lockdown in Melbourne).
I致e found this online.
https://rover.ebay.com/rover/0/0/0?m...2F202595585984 (https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com.au%2Fulk%2Fitm%2F202595585984)
I知 in a bit of a flux, one, I知 not wanting to spend up big, two , I知 a bit over Chinese Junk.
So , I知 a hypocrite at present.
Cheers Matt.
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205604&goto=newpost)
I知 not wanting to spend more than about $80 Au at present,
So , I知 not expecting to be able to buy a high end precision edge.
I will be mainly using it on some woodwork plane builds , that I知 planing , using metal,to check edges once ive filled them.
(One small note point , I do have a small surface plate, but I知 away from my workshop till we come out of lockdown in Melbourne).
I致e found this online.
https://rover.ebay.com/rover/0/0/0?m...2F202595585984 (https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com.au%2Fulk%2Fitm%2F202595585984)
I知 in a bit of a flux, one, I知 not wanting to spend up big, two , I知 a bit over Chinese Junk.
So , I知 a hypocrite at present.
Cheers Matt.
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205604&goto=newpost)