MWF FEED
19th September 2020, 12:30 PM
SAM_0705.jpg (https://metalworkforums.com/attachment.php?attachmentid=388781&d=1600477096)Hello from old BC.
This is a cheap ultrasonic cleaner, $35.00 from Aldi. I use hot water and dish drops to clean the cutters before I inspect and regrind them. It takes 3 mins for each load and just needs a wipe out with paper towels prior to putting it away. No need for solvent.
Regards
BC
Attached Images
https://metalworkforums.com/images/attach/jpg.gif SAM_0705.jpg (https://metalworkforums.com/attachment.php?attachmentid=388781&d=1600477096) (250.5 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205647&goto=newpost)
This is a cheap ultrasonic cleaner, $35.00 from Aldi. I use hot water and dish drops to clean the cutters before I inspect and regrind them. It takes 3 mins for each load and just needs a wipe out with paper towels prior to putting it away. No need for solvent.
Regards
BC
Attached Images
https://metalworkforums.com/images/attach/jpg.gif SAM_0705.jpg (https://metalworkforums.com/attachment.php?attachmentid=388781&d=1600477096) (250.5 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205647&goto=newpost)