MWF FEED
6th October 2020, 11:00 AM
I want to buy a WNMG carbide tool holder for my little south bend lathe but all the holders have a 16mm or larger shank, and my QCTP uses the 12mm holders.
Ive searched my heart out trying to find a holder for wnmg that goes into a 12mm post.
I wonder if there would be any real issue machining the bottom out of the holder to go from 16mm down to 12mm? Well I think 14mm will fit.
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205745&goto=newpost)
Ive searched my heart out trying to find a holder for wnmg that goes into a 12mm post.
I wonder if there would be any real issue machining the bottom out of the holder to go from 16mm down to 12mm? Well I think 14mm will fit.
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205745&goto=newpost)