Gray and Harper Bench Lathe

[lewisc]

Clearing out some gear from my school's workshop. We've had this lathe sitting around for years without use. It works though. Needs a tidy up. Comes with some tooling. 10A plug. Quite heavy. Can assist with loading - would be best on a low trailer. I don't know too much about it but If you have some questions, let me know and I'll try to find out from the other teacher.

$400 ONO
Pickup from Taylors Hill.

485138485139485140485141485142485143485144

[Tony Pridham]

Gee, wish I had the room for it. Good luck with the sale.

[Ironwood]

That appears to be the same as my lathe, they were badged and sold under many different brands. Mine is branded “Forbes”. Lantaine is another common one.
$400 is pretty much a bargain, especially if it comes with any change gears, and faceplates etc. I didn’t get change gears with mine, and only a 3-jaw chuck.
I would love to find someone willing to sell me a set of change gears.

[Bernmc]

Dammit. Would love a little metalworking lathe like this.

[dcarbonetti]

I would love for me and my brother, but i need to confirm if there is space in the shop for it and he isnt answering


Sent from my iPhone using Tapatalk

[builder]

I'll take it

[lewisc]

That was quicker than I thought. PM sent to builder. SOLD pending payment & pickup.

[dcarbonetti]

bugger, i should have been more clear that i meant "i will take it" and i just needed to work out where to put it

still keen on it and have found space in the shop for it

[lewisc]

bugger, i should have been more clear that i meant "i will take it" and i just needed to work out where to put it

still keen on it and have found space in the shop for it

Sorry about that one. Just going by the rules of the forum. IF (which I don't think it will) it falls through, I'll let you know.

EDIT: SOLD