MWF FEED
3rd December 2020, 11:10 AM
I dunno where I got this, but it looked useful. Obviously for holding work for something specific.
Any ideas? Some sort of parallel clamp? The upper bolt thread is not threaded into the lower 'jaw' -just located into it, but it threads into the top jaw.
Clamp2577.JPG (https://metalworkforums.com/attachment.php?attachmentid=389904&d=1606953728)
Attached Images
https://metalworkforums.com/images/attach/jpg.gif Clamp2577.JPG (https://metalworkforums.com/attachment.php?attachmentid=389904&d=1606953728) (61.5 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205983&goto=newpost)
Any ideas? Some sort of parallel clamp? The upper bolt thread is not threaded into the lower 'jaw' -just located into it, but it threads into the top jaw.
Clamp2577.JPG (https://metalworkforums.com/attachment.php?attachmentid=389904&d=1606953728)
Attached Images
https://metalworkforums.com/images/attach/jpg.gif Clamp2577.JPG (https://metalworkforums.com/attachment.php?attachmentid=389904&d=1606953728) (61.5 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=205983&goto=newpost)