MWF FEED
2nd December 2021, 10:50 AM
Hi all,
Just after some advice, I plan to make an aluminium melting furnace powered by propane and was just wondering if using cermamic board would be suitable as the lining instead of using cermamic blanket and then coating it with a high heat resistant coating.
Any advice/suggestions would be good.
Thanks
Sent from my SM-G935F using Tapatalk
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=207430&goto=newpost)
Just after some advice, I plan to make an aluminium melting furnace powered by propane and was just wondering if using cermamic board would be suitable as the lining instead of using cermamic blanket and then coating it with a high heat resistant coating.
Any advice/suggestions would be good.
Thanks
Sent from my SM-G935F using Tapatalk
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=207430&goto=newpost)