View Full Version : Cleaning spraygun
echnidna
11th December 2005, 02:22 PM
I have an old spraygun that was probably put away dirty by a previous owner.
I can't screw the pot off so I think I need to soak it something to loosen things up.
Any suggestions what to use.
journeyman Mick
11th December 2005, 02:44 PM
Bob,
if you're lucky it was nitrocellulose lacquer that was left in the pot. Soaking it in thinners will loosen it. If it's pretty much anything else it's probably stuck on permanently :( .
Mick
martrix
11th December 2005, 04:09 PM
try and jam some paint stripper in there
Harry72
11th December 2005, 05:41 PM
Is it a plastic or metal pot?
A metal pot may be able to be heated to soften the paint. Can you unscrew the pot's outlet riser from the gun handle?
soundman
19th December 2005, 11:41 PM
A long swim in thinners shifts most things.
well at least softens them.
Using the gun to apply sprayable contact cement also shifts lots of stuff.
cheers