Installing a lathe

[MWF FEED]

Hello all

I will be installing a lathe in my shed all up about 700Kg.
I am wanting to gain a little height and spread the load on the concrete.
The lathe comes with steel cabinets at each end.
Am I asking for problems if I put a sheet of 18mm Form Ply under the cabinets on top of the concrete.
Is this likely to cause accuracy problems down the track. The cabinets will be bolted through the Form Ply to the concrete.

Thanks Steve


Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=208104&goto=newpost)