MWF FEED
20th August 2022, 01:50 PM
I very seldom use a hand tap these days unless it's an unusual size but I'm interested to see the type of common size taps you guys use. Are you still going the taper, intermediate, plug route or like me use machine taps like spiral, gun & fluteless?
This is my setup for the common metric sizes where the drill, gun & spiral taps are in easy reach.DSCN1532.jpg (https://metalworkforums.com/attachment.php?attachmentid=399570&d=1660962291)
Attached Images
https://metalworkforums.com/images/attach/jpg.gif DSCN1532.jpg (https://metalworkforums.com/attachment.php?attachmentid=399570&d=1660962291) (168.6 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=208393&goto=newpost)
This is my setup for the common metric sizes where the drill, gun & spiral taps are in easy reach.DSCN1532.jpg (https://metalworkforums.com/attachment.php?attachmentid=399570&d=1660962291)
Attached Images
https://metalworkforums.com/images/attach/jpg.gif DSCN1532.jpg (https://metalworkforums.com/attachment.php?attachmentid=399570&d=1660962291) (168.6 KB)
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=208393&goto=newpost)