Burnerd Multisize chuck

[MWF FEED]

For reasons I can't explain, work had this buried in a cupboard. I can't explain it because none of the lathes there are D1-3, so why it was there in the first place is a mystery. My lathe at home is happily D1-3, so this is on holidays at the moment at my place. (Negotiations are continuing...) It is a Burnerd Multisize collet chuck. With the right collets it will do from 1/16" up to 1-1/2" diameter. The chuck is activated with a thing that looks like an overgrown drill chuck key.

DSCN9131.JPG (https://metalworkforums.com/attachment.php?attachmentid=401613&d=1676196557)

In the bottom of the original container were three bits of paper - instructions inseveral languages. As the paper has been on the receiving end of some harsh treatment, I thought I'd post scans here for posterity.

Chuck 2.pdf (https://metalworkforums.com/attachment.php?attachmentid=401611&d=1676196557) Chuck 3.pdf (https://metalworkforums.com/attachment.php?attachmentid=401610&d=1676196557) Chuck 1.pdf (https://metalworkforums.com/attachment.php?attachmentid=401612&d=1676196557)

Michael
Attached Images

https://metalworkforums.com/images/attach/jpg.gif DSCN9131.JPG (https://metalworkforums.com/attachment.php?attachmentid=401613&d=1676196557) (89.5 KB)

Attached Files

https://metalworkforums.com/images/attach/pdf.gif Chuck 2.pdf (https://metalworkforums.com/attachment.php?attachmentid=401611&d=1676196557) (684.3 KB)
https://metalworkforums.com/images/attach/pdf.gif Chuck 3.pdf (https://metalworkforums.com/attachment.php?attachmentid=401610&d=1676196557) (3.20 MB)
https://metalworkforums.com/images/attach/pdf.gif Chuck 1.pdf (https://metalworkforums.com/attachment.php?attachmentid=401612&d=1676196557) (933.2 KB)




Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=208918&goto=newpost)