MWF FEED
28th February 2023, 12:30 PM
How many of us keep snapping small milling cutters???
Do we find that our 3mm cutter is cutting oversize?
Well, hopefully, I've found what could be part of the problem.
You'll need to watch this 18minute video, by This Old Tony who just did a video on bad ER Collets to explain it all.
https://www.homemadetools.net/forum/...301#post219301 (https://www.homemadetools.net/forum/tpg-3-a-82496?utm_source=newsletter&utm_medium=email&utm_campaign=02-27-23&utm_content=02-27-23-219301&nls=nl&nl_ref=sub_16&fi=219301#post219301)
I hope this helps a lot.
Kryn
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=208955&goto=newpost)
Do we find that our 3mm cutter is cutting oversize?
Well, hopefully, I've found what could be part of the problem.
You'll need to watch this 18minute video, by This Old Tony who just did a video on bad ER Collets to explain it all.
https://www.homemadetools.net/forum/...301#post219301 (https://www.homemadetools.net/forum/tpg-3-a-82496?utm_source=newsletter&utm_medium=email&utm_campaign=02-27-23&utm_content=02-27-23-219301&nls=nl&nl_ref=sub_16&fi=219301#post219301)
I hope this helps a lot.
Kryn
Read the full thread at metalworkforums.com... (https://metalworkforums.com/showthread.php?t=208955&goto=newpost)