Ankali
9th March 2006, 11:32 AM
Hi
I have an MC 900 (CarbaTec Clone), about 3 years old, never done a lot of work (work and time are incompatible 4 letter words!!).
The motor is not spinning properly. I have checked the belt, mounts etc and all seems fine. If I remove the belt and flick the pulley on the motor, it spins up to full speed but put any load on it nad it slows right down.
I would like some advice before I start pulling the motor apart - anything I should be especially careful with?? Start by cleaning/regreasing bearings, any particular grease to use?
Ankali
I have an MC 900 (CarbaTec Clone), about 3 years old, never done a lot of work (work and time are incompatible 4 letter words!!).
The motor is not spinning properly. I have checked the belt, mounts etc and all seems fine. If I remove the belt and flick the pulley on the motor, it spins up to full speed but put any load on it nad it slows right down.
I would like some advice before I start pulling the motor apart - anything I should be especially careful with?? Start by cleaning/regreasing bearings, any particular grease to use?
Ankali