jacko
5th January 2003, 07:09 PM
I bought a 14" bandsaw from Hare and Forbes about 10 months ago, welded frame construction. Supposed to be OK for up to 3/4" blades. DOing some resawing of Woolybut at about max thickness, something has let go and now the blde will still track, but on the front half of the bottom wheel, almost on the edge. Still works, but saw is no longer at right angles to the table top (for to aft) and the guide has to be re-adjusted every time I move the bar up or down. H and F could not offer any suggestions, so over to the greater reading public, has anybody got any great ideas as to where the problem might be and what the solution? ( other than junk the whole shebang, which I just might end up doing)
Jacko
Jacko