strangerep
10th September 2006, 12:15 PM
I hope this question about screws is allowed here.
(They're going into blackbutt, so I figured maybe it's ok.)
Anyway...
I want some screws with the following specs:
- Type-17 tip
- Gal (i.e: not merely zinc plated)
- Countersunk
- Square/Hex socket drive preferred (else Phillips)
- 8g, 10g, or 12g (prefer 10g)
- 30mm length (but would accept 25mm-35mm)
Does anyone know of a supplier/manufacturer of such screws?
(I can get zinc-plated ones from Buildex, but they don't seem to
offer them in gal. Stainless is too soft for rough treatment going
into hardwood, and usually quite expensive.)
TIA.
(They're going into blackbutt, so I figured maybe it's ok.)
Anyway...
I want some screws with the following specs:
- Type-17 tip
- Gal (i.e: not merely zinc plated)
- Countersunk
- Square/Hex socket drive preferred (else Phillips)
- 8g, 10g, or 12g (prefer 10g)
- 30mm length (but would accept 25mm-35mm)
Does anyone know of a supplier/manufacturer of such screws?
(I can get zinc-plated ones from Buildex, but they don't seem to
offer them in gal. Stainless is too soft for rough treatment going
into hardwood, and usually quite expensive.)
TIA.