View Full Version : Replacement drive belts
rtyuiop
24th June 2003, 05:42 PM
Hi all,
I'm looking for a replacement drive belt for my late grandfather's lathe (a Craftmaster CWL-1000S, which it seems nobody's ever heard of!). Anyone have any ideas on the best place to find such things? I've sent email off to a couple of places in Brisbane, but no joy so far.
Looking to get back into woodwork in general and turning in particular after not doing any for 3 years or so, should be fun :).
Thanks,
Danny Smith
rsser
24th June 2003, 10:11 PM
An industrial supplies place will keep basic belts and can refer you to specialist suppliers.
Do you have the old one as a sample? Belts vary not only in length but also cross-section.
Cheers,
Ern
rtyuiop
25th June 2003, 10:01 AM
Thanks Ern, will give that a go - I do have the original belt, so hopefully a replacement won't be too hard to find.
Cheers,
Danny
rtyuiop
28th June 2003, 02:07 PM
Found one!
In case it might come in handy for anyone else, Lewis Hoses & Seals (in Slacks Creek, just near Moss St) has a pretty good selection of belts, including one that pretty much perfectly matched what I needed. All for the princely sum of $6.05.
Cheers,
Danny
glansley
22nd July 2007, 06:14 PM
Just wondered if u no what size the belt was i have the same lathe and just broke a belt.
Greg A
8th December 2023, 09:46 AM
Hi I am looking for a belt for my fathers lathe but he has lost the old ones. Does someone have the spec? I am in Brisbane
EagerBeaver71
8th December 2023, 10:22 AM
Whats the belt made of?
EagerBeaver71
8th December 2023, 10:26 AM
If its Rubber, I recently got mine from here:
Industrial Power Transmission Products | Naismith Engineering (https://www.naismith.com.au/)
aldav
8th December 2023, 11:58 AM
Might have to change your handle to 'OverEagerBeaver'. :D Last post on this thread prior to your two today was over 16 years ago. :oo:
EagerBeaver71
8th December 2023, 01:28 PM
Might have to change your handle to 'OverEagerBeaver'. :D Last post on this thread prior to your two today was over 16 years ago. :oo:
OMG you're right!, what a complete idiot I am!, I'll scuttle off and change my name!.:doh:
DJ’s Timber
8th December 2023, 02:00 PM
Might have to change your handle to 'OverEagerBeaver'. :D Last post on this thread prior to your two today was over 16 years ago. :oo:
OMG you're right!, what a complete idiot I am!, I'll scuttle off and change my name!.:doh:
Not anymore, post was in moderation
orraloon
8th December 2023, 03:47 PM
Dont worry most of us can forget to look at the post date at times. Suckered me too.
Regards
John
aldav
8th December 2023, 03:53 PM
Dont worry most of us can forget to look at the post date at times. Suckered me too.
Regards
John
Me too! :wink: