I cant get my plan to fill

[zendo]

Ihave done 2D floor plan but part of the floor will not fill can any one shed some light

[martrix]

Ive had a look at your drawing and the only thing I can suggest is to try re-drawing sections. I say this because I found at least one line that was not on-axis. Looking up close I also found a line that didn't line-up with another and so looked like it was out by maybe 5mm, yet when I measured it said 0.00mm:? .

Did you change something like a setting or preference half way through drawing?

[martrix]

On second thoughts I would draw the whole thing again.:C Something is off axis and things aren't lining up.

When drawing lines and joining them up to others, makes sure they turn red, blue, green depending on what axis you are on before completing the line.

http://www.woodworkforums.ubeaut.com.au/attachment.php?attachmentid=48897&stc=1&d=1182509998