petert
14th September 2003, 10:35 PM
My apologies if this question has been asked previously or if the forum considers it off topic.
I'm in process of constructing a jig for finger jointing, need 3/8" 16 tpi metal threaded rod and tee nuts. I realise that 10mm 1.5 rod and nuts is a possible (but not optimum) alternative. The 16 tpi requirement stems from a design requirement that 2 full turns equivalences to a 1/8" kerf.
Need pointers to suppliers of tee nuts (preferably UNF) in the Pakenham/Narrewarren/Cranbourne area in Victoria. Will be trying the yellow pages bolt/nut suppliers on Monday but hopefully this forum can eliminate the dross. Bunnies dont stock UNF or metric tee nuts from discussion with them on Saturday.
All pointers gratefully received.
Thanks
I'm in process of constructing a jig for finger jointing, need 3/8" 16 tpi metal threaded rod and tee nuts. I realise that 10mm 1.5 rod and nuts is a possible (but not optimum) alternative. The 16 tpi requirement stems from a design requirement that 2 full turns equivalences to a 1/8" kerf.
Need pointers to suppliers of tee nuts (preferably UNF) in the Pakenham/Narrewarren/Cranbourne area in Victoria. Will be trying the yellow pages bolt/nut suppliers on Monday but hopefully this forum can eliminate the dross. Bunnies dont stock UNF or metric tee nuts from discussion with them on Saturday.
All pointers gratefully received.
Thanks