specialist
27th September 2007, 11:19 PM
I couldn't find a post that would cover this, so if it is doubled, I'm sorry.
I don't have a jointer, so in the past I've had to resort to a straight edge and router for jointing. It used to take forever.:~
I got the idea from a book or internet somewhere. They used a bobbin sander.
I just thicknessed two boards, one 1mm thinner than the other and bolted them to the front of my router fence. My fence obviously not straight hence the 4 thicknesses of paper shims to make the pine boards parallel.
The last pic shows three boards butted up together, not clamped to show the joins. I clamped them at one end and the other end openned up about 1mm under pressure, so that is good enough for now untill I can get the reall thing.
I don't have a jointer, so in the past I've had to resort to a straight edge and router for jointing. It used to take forever.:~
I got the idea from a book or internet somewhere. They used a bobbin sander.
I just thicknessed two boards, one 1mm thinner than the other and bolted them to the front of my router fence. My fence obviously not straight hence the 4 thicknesses of paper shims to make the pine boards parallel.
The last pic shows three boards butted up together, not clamped to show the joins. I clamped them at one end and the other end openned up about 1mm under pressure, so that is good enough for now untill I can get the reall thing.