wheelinround
10th March 2008, 06:33 PM
This was started in another thread
http://www.woodworkforums.com/showpost.php?p=694476&postcount=7
rather than hikack rgums thread even more.
The Claret Ash was given to me by some top blokes Ornimental Turners :2tsup:
My first reaction :D next :doh: when I saw the lump missing would the little Jet Mini handle it, would I stuff it right up.:C So it sat on the back of the bench for a few weeks till I got tired of moving it round. :roll: Trying to decide what to do with such nice piece.
Thanks to those for the advice re the bark section super glue did the trick :2tsup: held firm even filled the small bit that flew and left a hole. Had to use some also on the :~ little knot that appeared as I got down close to the bottom it does not go right through.
Unlike one of the other fellows who found a 3" bolt in the middle of his bit spat his gouge clear cross the room :oo::o.
I say its a WIP as I feel its not quite finished its missing something :rolleyes: its 200mm dia x 80mm h
well here's the photos
http://www.woodworkforums.com/showpost.php?p=694476&postcount=7
rather than hikack rgums thread even more.
The Claret Ash was given to me by some top blokes Ornimental Turners :2tsup:
My first reaction :D next :doh: when I saw the lump missing would the little Jet Mini handle it, would I stuff it right up.:C So it sat on the back of the bench for a few weeks till I got tired of moving it round. :roll: Trying to decide what to do with such nice piece.
Thanks to those for the advice re the bark section super glue did the trick :2tsup: held firm even filled the small bit that flew and left a hole. Had to use some also on the :~ little knot that appeared as I got down close to the bottom it does not go right through.
Unlike one of the other fellows who found a 3" bolt in the middle of his bit spat his gouge clear cross the room :oo::o.
I say its a WIP as I feel its not quite finished its missing something :rolleyes: its 200mm dia x 80mm h
well here's the photos