cschebel
13th March 2008, 02:32 PM
Hi All,
I'm in the process of upgrading my dust collector (an old 1HP Scheppach) to something a bit bigger.
My original plan was to move to something like a CT-002V 2HP (Carbatec) with twin bags and supposedly rated at 2000 cfm?? To keep the cfm as high as possible I'm planning to use 6 inch ductwork. However, all the collectors I've had a look at have only 4 inch ports (sometimes they have three 4 inch ports such as in the case of the CT-002V).
So my question is - how do you connect 6-inch ducting to an extractor with a 4-inch inlet? Are there manufacturers that provide a 6-inch replacements to the standard 4-inch inlet?
Please note, i'm not after a 4-inch-to-6-inch duct adaptor.. rather a replacement of the actual inlet setup itself.
Regards,
Callan
I'm in the process of upgrading my dust collector (an old 1HP Scheppach) to something a bit bigger.
My original plan was to move to something like a CT-002V 2HP (Carbatec) with twin bags and supposedly rated at 2000 cfm?? To keep the cfm as high as possible I'm planning to use 6 inch ductwork. However, all the collectors I've had a look at have only 4 inch ports (sometimes they have three 4 inch ports such as in the case of the CT-002V).
So my question is - how do you connect 6-inch ducting to an extractor with a 4-inch inlet? Are there manufacturers that provide a 6-inch replacements to the standard 4-inch inlet?
Please note, i'm not after a 4-inch-to-6-inch duct adaptor.. rather a replacement of the actual inlet setup itself.
Regards,
Callan