No 1 Morse Taper Drive Spur

[stevew]

Could someone help me with a Number 1 drive spur ,I am going to slip it into a no 2 reducer so I can use it in the lathe without constantly removing the Vicmarc chuck.
With pay postage and handling.Look forward to some advice or replies.
Thank you.
Steve

[TTIT]

Why not give a Steb-style drive (http://www.carbatec.com.au/woodturning-tools/drive-spurs-live-centres/carba-tec-drive-centres/carba-tec-steb-style-drive-centre) centre a try or just cut a groove at the top of the taper of your current drive. The Vicmark jaws grab the drive in the groove perfectly :2tsup: so you don't have to take the chuck off at all - - - - - - - - - until you get another chuck - - - - - - - - - and vacuum chucks - - - - - - - - and another chuck - - - - - - -


:B I've only got 3 - Cliff's the man! :;

[rsser]

Or: Teknatool make a small drive spur that fits their chucks ... might be worth asking how they'd go in VM chucks.

http://www.teknatool.com/products/Chuck_Accessories/SpurCenter.htm

[Jim Carroll]

They do fit on the VM chucks just not as much coverage in the ring part as the nova chucks.

Will do the job as long as it was not a big heavy peice.