John H
20th August 2008, 08:30 PM
I picked up a quick change tooling system for my X4 Mill from Toolmach Australia (http://www.toolmach.com.au). I haven't set it up fully yet but it sure does make it easier to swap tools.
It's basically the same as the Tormach system and even has "TTS" on the parts so perhaps made in the same factory? Comes with a granite block and height gauge but I have to make up part to sit the tool holders to set their heights.
I also grabbed the vise in the photo too and I've set it up with 0.05mm variance across the face. 110mm Jaw opening and it's not too bad.
It's basically the same as the Tormach system and even has "TTS" on the parts so perhaps made in the same factory? Comes with a granite block and height gauge but I have to make up part to sit the tool holders to set their heights.
I also grabbed the vise in the photo too and I've set it up with 0.05mm variance across the face. 110mm Jaw opening and it's not too bad.