PDA

View Full Version : Nova Comet Lathe



Mal
7th May 2000, 12:38 AM
G'day,

I'm about to venture into the world of woodturning. She who must nearly always be obeyed has approved the purchase of a lathe. I'm looking at a Nova Comet. If this turns (bad pun, I know) out to be a passion, like fishing did, I'll own it forever and use it heaps. Any advice on whether this is a suitable choice, or any other not too scathing comments would be much appreciated. Also, would I be better off waiting until after the introduction of the GST or buying beforehand?

------------------
Luv
Mal


[This message has been edited by Mal (edited 07 May 2000).]