Incra ultra lite jig clamping

[panofish]

I bought an incra ultra lite jig and I'm curious what you guys think about how I should clamp it to my table. I explain more detail in a video clip on my blog...

http://panofish.net/2009-04-20_Incra_Jig

[aju]

Hi,

I had a very similar problem. My solution was to use MagJig magnets (http://www.magswitch.com.au/mag-jigs/30mm-mag-jig.html). These are on/off rare earth magnets as shown in the following link http://www.woodworkforums.ubeaut.com.au/showthread.php?t=75928. (http://www.woodworkforums.ubeaut.com.au/showthread.php?t=75928)

You will have to make your board larger to reach the cast iron top of the tablesaw.

Hope this helps

[panofish]

I like it... I think I may make one using the cheaper harbor freight magnetic switch bases.
I've already made some magnetic featherboards with these and they work well.
I may need 3 hf switches to ensure it is solidly clamped.