View Full Version : Australian woodturning exhibition
mick61
17th May 2009, 09:00 PM
G`day how many forumities are entering this year?
Mick:D
rsser
17th May 2009, 10:31 PM
Something to think about Mick.
Can you post a link to the website?
mick61
17th May 2009, 11:58 PM
Ok http://theaustralianwoodturningexhibition.com
Mick
P.S there isn`t much time left to get forms in but there is a bit of time to complete pieces.
tea lady
18th May 2009, 12:01 AM
Google? :D:p
http://www.theaustralianwoodturningexhibition.com/
Entries close 22nd May or there abouts. :think:
Skew ChiDAMN!!
18th May 2009, 12:05 AM
Not this year. Mebbe next year I'll throw something in again. :)
But I'll be attending, just the same. (Wouldn't miss it!)
nine fingers
18th May 2009, 09:39 AM
First time, still a novice at 73.:oo:
nine fingers
robbiebgraham
18th May 2009, 12:59 PM
Mick, Can you enter if you are out side Australia? I can't find anything on the entry form or rules.:?
Robbie
Manuka Jock
18th May 2009, 01:24 PM
Mick, Can you enter if you are out side Australia? I can't find anything on the entry form or rules.:?
Robbie
Robbie ,
just tell them Aussies you're a musician ,
they'll claim ya . :D
Rum Pig
18th May 2009, 01:44 PM
Bit out of my league:o so I will need to practise some more:U
Mulgabill
18th May 2009, 05:55 PM
Hey Robbie!
You can contact Ray Dennis on the advertised email address for the Exhibition in the current The Australian Woodworker magazine which is
[email protected]. Failing that I have a personal contact for Daryle Broadhurst if you would like me to PM you that.
Cheers
robbiebgraham
18th May 2009, 09:46 PM
Thanks, I know Daryle, so I will flick him an email. The exhibition is probably like ours and you have to be from NZ but I don't think it is on the enrollment form either!
It would be two late this year anyway but I will follow it up.
Cheers,
Robbie
Mulgabill
19th May 2009, 05:53 PM
Alls good Robbie, I will be seeing DB tomorrow and fill him in. I am not sure myself regarding international entries, however, your assumptions could very well be right.:question:
Regards
Russell
tea lady
20th May 2009, 07:54 PM
So just a silly question from the greying blond down the back........ Is a square platter diameter taken from corner to corner? :C :blond:
Manuka Jock
20th May 2009, 08:13 PM
So just a silly question from the greying blond down the back........ Is a square platter diameter taken from corner to corner? :C :blond:
Yep , and from the base to the highest point too .
Measure it to the max lass ...:2tsup: