Could this be used as a pressure pot

[madcraft]

Hi Guys/Girls

I was wondering if this would be suitable to use as a pressure pot for stabilizing



Its a 2 Lt press paint pot that's hooked to a Compressor
http://www.madcraftcottage.com.au//images/presspot.jpg


2 Lt Pressure Tank provides pressurized material up to a maximum of 44 PSI.
This tank is equipped with an air regulator, gauge and fluid outlet.

It is constructed of only the finest materials for durability.

The 2 Lt capacity enables you to handle most any job with professional results.

This versatile tank can also spray materials other than paint.

Features:


2 Lt Paint Tank
Operating Pressure: 2.0 - 3.0 BAR
(30-44PSI)
Air Comsumption: 6.0 - 8.8 CFM
Patern 180 - 230mm
Complete with air line and paint fluid line
Pressure gauge
Spray gun head
2 lt pressure pot
Easy to clean pot

[NewLondon88]

It could work, but I doubt you'd have room to put anything in it. The
surface area on the bottom (where you would put your mold) seems
very small.

[dj_pnevans]

What say if you lay it down on it side.
David

[NewLondon88]

you might need to get creative .. but you're looking to hold pressure till your
resin sets. If you can make it work, go for it! Don't forget to post pics..:D